New guy here! 600whp or bust build

[aLmk]

Well ya be shouldn't have any creep!

[Si Speed 317]

Updates? This came out so sick!

[Si Speed 317]

i suppose in his chassis be a lot of work, but in an eg/ek/dc like mine, it wouldnt be much. I hate creep, and i have it.

Have you looked into a 4-port electronic boost controller?

[boosted_teg]

Have you looked into a 4-port electronic boost controller?

no i havent. would that actually make a difference over a 3 port? i know you can run a lower psi spring and run higher boost pressire

[1SLOWFG2]

So I got the car back and am just about done putting it all back together! Just finishing up the plumbing and waiting to get my intake manifold back tomorrow !

Relocated the ecu, all battery cables relocated, battery is under the bumper.



Box of goodies









More updates and pictures after its all done, powdercoating a few parts, and should be on the road sometime during the week!

[1SLOWFG2]

245/40/16





^^^^^this comp turbo makes my 6062 look tiny!

[aLmk]

So I got the car back and am just about done putting it all back together! Just finishing up the plumbing and waiting to get my intake manifold back tomorrow !

Relocated the ecu, all battery cables relocated, battery is under the bumper.



Box of goodies









More updates and pictures after its all done, powdercoating a few parts, and should be on the road sometime during the week!

Where was the car? What are you doing about the transmission?

245/40/16





^^^^^this comp turbo makes my 6062 look tiny!

What is that wiring thing going into the wheel well? Also is that intercooler the same as the one I have minus the piping coming off it. I'm wondering if I can modify it like that to make it so a bumper will fit without cutting and fix my charge pipe in wheel well issue.
Everything looks sweet! Can't wait to see the numbers and some videos!

[1SLOWFG2]

My car was at the shop, it's at my house to do all the wiring, and plumbing.

Same intercooler but 3.5" thick instead of 3"

[1SLOWFG2]

Wiring is not all supported, not sure if your talking about my headlight harness, or the battery cables?

[aLmk]

My car was at the shop, it's at my house to do all the wiring, and plumbing.

Same intercooler but 3.5" thick instead of 3"

Ok did you delete the AC cooler that sits in front of the radiator? I was messing with my piping today to get better clearance in my wheel well, so I had my bumper off and I was looking at mine at comparing it to your picture. I'm just curious how you got 2, 2.5'' pipes to fit in that spot right off the intercooler. I can see you removed the plastic shield thing, but even with that gone I'm not sure there would be a whole lot of room. Tough to tell in that photo if the AC cooler thing (sorry don't know technical name) is there.

Wiring is not all supported, not sure if your talking about my headlight harness, or the battery cables?

Gotcha, makes sense.

And I was able to get a bit more clearance in my wheel well, and my wheel was not hitting the fender liner on a full right turn, I just hope it also has enough clearance for 15x8 wheels with 24.5x85 slicks.